Advanced Hand-Cut Dovetails Dvd

Advanced Hand-Cut Dovetails Dvd

$24.95

Bench-side instruction on hand-cutting hounds tooth, half-blind and mitered edge dovetails. Building on Hand Cut Dovetails...[Read More]
Buy Now

Bench Chisels

Bench Chisels
$19.95

This will probably
be one of the most beneficial hours
you have spent learning woodwork. Chisels are such a fundamental...
[Read More]

Buy Now


   
 

UK Planes and their Makers


 
  Early Mortise Gauges by Richard Arnold  

 

These wooden gauges were found in an 18th century joiners chest.

 

They are cut from the solid, and are not adjustable. My theory is that they were for sash window making. Both originally had four fixed pins.

These seem to match the two common sizes of sash material used in England, 1-1/2", and 1-3/4".

The first two pins would mark the position of the mortice, while the third would mark the overall width of the sash, while the fourth pin would mark an extra 1/4" width for the meeting rails.

Both have seen an extreme amount of use, as the wear in the end grain testifies.

I have concluded from this that it was not just the position of the mortise and tenon that was marked, but the whole length of the rails, stiles, and glazing bars.

Aichard Arnold
May, 2017
Website: http://oldwoodplanes.co.uk/


 
468x60
 

Mosley



   

Copyright 2005-2017, wkFineTools.com and Wiktor Kuc.  All Rights Reserved.  Designated trademarks and brands are the property of their respective owners.
No part of the content from this website can be reproduced by any means without specific permission of the publisher.
Valid CSS!